How I Mounted My LED Shop Lights In The Garage
08-30-2020, 10:45 PM
<iframe width="560" height="315" src="https://www.youtube.com/embed/3vjaBCgRtJs" frameborder="0" allow="accelerometer; autoplay; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe>
I was pretty happy with how this turned out. At first I wasn't so sure how I wanted to mount the lights in the foam since it isn't all that easy to get to the backside. The LED lights a really lightweight so I am pretty confident it will hold just fine.
It took a lot longer than I thought to get the foam boards up there but I am really hoping it holds the heat in the garage better. The rafters have (always have had since I've owned the house) R11 insulation. This 2 inch foam board is R10 and I had about 30 4ft rolls of R6.7 insulation that was free after rebate from menards laying on top of the foam boards.
I was pretty happy with how this turned out. At first I wasn't so sure how I wanted to mount the lights in the foam since it isn't all that easy to get to the backside. The LED lights a really lightweight so I am pretty confident it will hold just fine.
It took a lot longer than I thought to get the foam boards up there but I am really hoping it holds the heat in the garage better. The rafters have (always have had since I've owned the house) R11 insulation. This 2 inch foam board is R10 and I had about 30 4ft rolls of R6.7 insulation that was free after rebate from menards laying on top of the foam boards.